Wireless Keypad (Model OWK-BX)
Basic Instructions
Testing Garage Door Opener
- Enter your personal identification number (PIN).
- Press the button with the arrow up/down triangles.
Resetting/Clearing Keypad
- Press and hold the PROG button. Keep holding and proceed to step two.
- Press and hold the 6 button. Keep holding and proceed to step three.
- Press the key with the arrow up/down triangles.
Setting PIN On Keypad
- Press the following keys in order: 3, 5, 7, PROG (red LED blinks once per second).
- Enter your PIN (three to eight characters).
- Press the PROG key again (red LED blinks twice per second and turns off).
Getting Started
Before you begin, be aware of the following:
For convenience, program your keypad before mounting.If programming your garage door opener is disrupted at any point due to program failure, clear/reset your keypad. Then, start over. Locate the “Learn Code” button and the “Learn Code” red LED indicator.
Programming One Garage Door Opener
- Press the “Learn Code” button once (red LED indicator will blink).
- Enter your PIN.
- Press the button with the arrow up/down triangles. The “Learn Code” indicator LED will stay on.
- Press the button with the arrow up/down triangles a second time. The “Learn Code” indicator LED will turn off.
- Press the button with the arrow up/down triangles a third time. Garage door should now move.
Programming Two Or Three Garage Door Openers
All garage door openers will use the same PIN.
Programming The Wireless Keypad
- Enter your PIN and press the PROG button (red LED blinks once per second).
- Press the PROG button a second time (red LED blinks twice per second).
- Press the total number of doors you wish to control (either 2 or 3).
- Press the PROG button a third time (red LED blinks several times and turns off).
Programming Garage Door Opener
- Decide which door will be Door 1, 2 and 3. “Learn Code” indicator LED (on opener) blinks.
- Enter your PIN and press the arrow up/down triangle button. “Learn Code” indicator LED continues to blink.
- Press the number you have picked for this door opener: 1, 2 or 3. “Learn Code” indicator LED stays on.
- Press the arrow up/down triangle button a second time. “Learn Code” indicator LED turns off.
- Press the arrow up/down triangle button a third time. Garage door should move.
- Repeat steps one through five for programming each garage door opener. Each door opener must be programmed to receive the signal from the wireless keypad.
Troubleshooting Tips
- If the garage door does not move, check the red LED on the keypad.
- If the LED blinks rapidly, the PIN was entered incorrectly.
- Any keypad button will control the door for 30 seconds after the door starts moving.
- Rapid blinking of the LED indicates an error. After a few seconds, the LED will turn off, and you can retry.
- If the red LED does not blink during use, the battery needs to be changed.
Mounting Instructions
- Remove the battery cover.
- Drill a 1/16" hole for the top mounting screw.
- Install a screw into the top drilled hole, leaving a 1/8" gap between the screw head and the wall.
- Hook the keypad over the screw.
- Mark the bottom hole, then screw in the bottom screw.
- Reinstall the battery cover.
Additional Assistance
Should you need additional information about installing or programming your garage door opener or remote, please call customer service at 865.573.1950, or contact us.